Wiper Motor Replacement

WIPER MOTOR REPLACEMENT

TOOLS REQUIRED
- J 39232 Wiper Transmission Separator
- J 39529 Wiper Transmission Installer

REMOVAL PROCEDURE




1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Disconnect the electrical connector from the wiper motor.




4. Remove the 4 bolts retaining the wiper system drive module.




5. Remove the wiper drive system module from the vehicle.




6. Disconnect the drive link from the wiper motor crank arm using the J 39232.




7. Remove the 2 bolts retaining the wiper motor.
8. Remove the wiper motor from the wiper drive system module.

INSTALLATION PROCEDURE

1. NOTE: Refer to Fastener Notice.




Install the wiper motor onto the wiper drive system module with the 2 bolts.

Tighten the bolts to 8 N.m (71 lb in).




2. Connect the drive link onto the wiper motor crank arm using the J 39529.




3. Install the wiper drive system module on the vehicle.




4. Install the 4 bolts.

Tighten the bolts to 8 N.m (71 lb in).




5. Connect the electrical connector to the wiper motor.
6. Install the air inlet grille panel.
7. Install the wiper arms.
8. Operate the wipers and inspect for proper operation.