Wheel Drive Shaft Heat Shield Replacement (W/RPO M86)

Wheel Drive Shaft Heat Shield Replacement (w/RPO M86)

Removal Procedure




1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel drive shaft heat shield-to-transaxle mount bracket bolt.
3. Remove the drive shaft heat shield-to-engine block bolt.
4. Remove the wheel drive shaft heat shield.

Installation Procedure




1. Position the wheel drive shaft heat shield onto the engine.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the wheel drive shaft heat shield-to-engine block bolt.

Tighten the bolt to 30 N.m (22 lb ft).

3. Install the wheel drive shaft heat shield-to-transaxle mount bracket bolt.

Tighten the bolt to 10 N.m (89 lb in).

4. Lower the vehicle.