Tire Pressure Monitoring

DTC C0569

Diagnostic Instructions

- Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
- Review Strategy Based Diagnosis for an overview of the diagnostic approach.
- Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0569 00: System Configuration Error .

Circuit/System Description

The remote control door lock receiver (RCDLR) receives a radio frequency (RF) transmission from each tire pressure sensor. Each sensors RF transmission contains its own unique identification (ID) code that must be learned into the RCDLR memory. Once all 4 IDs have been learned and vehicle speed is 25 mph, or greater, the RCDLR continuously compares IDs in received transmission to its learned IDs to determine if all 4 sensors are present.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The RCDLR has not undergone the programming procedure.

Action Taken When the DTC Sets

The driver information center (DIC) displays the SERVICE TIRE MONITOR warning message.

Conditions for Clearing the DTC

A current DTC will clear when the RCDLR has undergone the setup procedure.

Diagnostic Aids

A newly replaced RCDLR will set DTC C0569 on its initial ignition ON cycle. Tire type and tire pressure selection setup must be performed.

Circuit/System Verification

Verify that the DTC C0569 is not set.
-> If the DTC is set, program/setup the RCDLR. If the DTC resets, replace the RCDLR.