Stabilizer Shaft Insulator Replacement (2500 Series)

Stabilizer Shaft Insulator Replacement (2500 Series)

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the engine protection shield.




3. Remove the insulator clamp bolts.
4. Remove the clamps.
5. Remove the insulators.
6. Inspect all of the parts for wear and damage.

Installation Procedure




1. Place the insulators on the stabilizer shaft with the slits facing toward the front of the vehicle.




2. Install the insulators to the stabilizer shaft.
3. Install the stabilizer shaft.
4. Install the clamps over the insulators and the stabilizer shaft.

Notice: Refer to Fastener Notice.

5. Install insulator clamp bolts.

Tighten the bolts to 50 N.m (37 lb ft).

6. Install the engine protection shield.
7. Lower the vehicle.