Forward Servo Replacement
Forward Servo Replacement
Removal Procedure
1. Remove the transmission filter.
2. Remove the forward servo cover bolts, cover, and gasket.
3. Remove the following parts:
1. Forward servo piston pin (5)
2. O-ring seal (4)
3. Servo piston (3)
4. Retainer (2)
5. Piston spring (1)
Installation Procedure
1. Install the following parts:
^ Piston spring (1)
^ Retainer (2)
^ Servo piston (3)
^ O-ring seal (4)
^ Forward servo piston pin (5)
Notice: Refer to Fastener Notice.
2. Install the forward servo gasket, cover, and bolts.
Tighten the bolts to 24 N.m (18 lb ft).
3. Install the transmission filter.
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
4. Reset the TAP values. Refer to Transmission Adaptive Functions.