Filler Tube and Seal Replacement

Filler Tube and Seal Replacement

Removal Procedure

1. Remove the intake manifold.

2. Unlock the transmission oil level indicator.
3. Remove the transmission oil level indicator.
4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
5. Support the transmission using a suitable jack.
6. Remove the transmission crossmember.

7. Loosen the left exhaust pipe nuts.

8. Loosen the right exhaust pipe nuts.

9. Remove the transmission heat shield.
10. Lower the transmission slightly.

11. Disconnect the transmission oil cooler lines.
12. Plug the transmission oil cooler line fittings.

13. Remove the indicator tube nut.

14. Remove the indicator tube bolt, if equipped with RPO HP2.

15. Remove the oil level indicator tube.
16. Remove the seal from the transmission, if necessary.

17. Remove the oil level indicator tube, if equipped with RPO HP2.
18. Remove the seal from the transmission, if necessary.

Installation Procedure

1. Install a NEW seal to the indicator tube.
2. Install the oil level indicator tube, if equipped with RPO HP2.

3. Install a NEW seal to the indicator tube.
4. Install the oil level indicator tube.

Notice: Refer to Fastener Notice.

5. Install the indicator tube bolt, if equipped with RPO HP2.

Tighten the bolt to 18 N.m (13 lb ft).

6. Install the indicator tube nut.

Tighten the nut to 18 N.m (13 lb ft).

7. Remove the plugs from the transmission oil cooler line fittings.
8. Connect the transmission oil cooler lines.

9. Remove the transmission heat shield.

Tighten the bolts to 17 N.m (12 lb ft).

10. Tighten the right exhaust pipe nuts.

Tighten the nuts to 50 N.m (37 lb ft).

11. Tighten the left exhaust pipe nuts.

Tighten the nuts to 50 N.m (37 lb ft).

12. Install the transmission crossmember.
13. Remove the support from the transmission.
14. Lower the vehicle.

15. Install the transmission oil level indicator.
16. Lock the transmission oil level indicator.
17. Install the intake manifold.