Transmission Housing Oil Seal Replacement - Rear (RWD)

Transmission Housing Oil Seal Replacement - Rear (RWD)

Tools Required

J 45868 RWD Output Shaft Seal Installer

Removal Procedure

1. Remove the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement (One-Piece Propeller Shaft Replacement) or Two-Piece Propeller Shaft Replacement (Two-Piece Propeller Shaft Replacement) .




2. Using a suitable tool, pry the rear transmission housing oil seal from the transmission housing.

Installation Procedure




1. Using the J 45868 and a hammer, install the NEW rear transmission housing oil seal.
2. Check the transmission fluid level. Add if necessary. Refer to Transmission Fluid Replacement (Transmission Fluid Replacement) .
3. Install the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement (One-Piece Propeller Shaft Replacement) or Two-Piece Propeller Shaft Replacement (Two-Piece Propeller Shaft Replacement) .