Parking Brake Rear Cable Replacement - Left Side

Parking Brake Rear Cable Replacement - Left Side

Special Tools

CH-37043 - Parking Brake Cable Release Tool

For equivalent regional tools, refer to Special Tools Tools and Equipment.

Removal Procedure

Warning:
Refer to Brake Dust Warning Brake Dust Warning.


1. Disable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Disabling Parking Brake Cable Adjuster Disabling.

2. Turn the ignition to the OFF position.

3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

4. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.





5. Disconnect the parking brake intermediate cable nut (1) from the electronic parking brake control module spindle by rotating the nut counterclockwise.

6. Disconnect the parking brake intermediate cable and position the cable aside.





7. Remove the intermediate parking brake cable forward bracket bolt (1).

8. Lower the rear suspension support approximately 152-254 mm (6-10 in) to access the parking brake cable fasteners. Refer to Support Replacement Service and Repair.





9. Remove the intermediate parking brake cable lower support bracket bolt (1).





10. Remove the intermediate parking brake cable upper support bracket bolt (1).





11. Disconnect the intermediate parking brake cable from the right rear parking brake cable connector (1).





12. Using the CH-37043 - Parking Brake Cable Release Tool, compress the locking tabs on the left rear parking brake cable conduit (1) and remove the parking brake cable from the support bracket.

13. Disconnect the left rear parking brake cable from the parking brake cable equalizer.





14. Disconnect the left parking brake cable eyelet (1) from the parking brake actuator.

15. Using the CH-37043 - Parking Brake Cable Release Tool, remove the parking brake cable (2) from the parking brake cable bracket.

16. Remove the intermediate parking brake cable from the rear suspension support.

17. Separate the intermediate and rear left parking brake cables.

Installation Procedure

1. Connect the intermediate and rear left parking brake cables.





2. Connect the left parking brake cable eyelet (1) to the parking brake actuator.

3. Install the left parking brake cable (2) to the parking brake cable bracket.

4. Ensure the locking tabs on the cable conduit are securely engaged to the cable bracket.





5. Connect the left rear parking brake cable to the parking brake cable equalizer.

6. Install the parking brake cable to the support bracket.

7. Ensure the locking tabs on the left rear parking brake cable conduit (1) are securely engaged to the support bracket.





8. Connect the intermediate parking brake cable to the right rear parking brake cable connector (1).





Caution:
Refer to Fastener Caution Fastener Caution.

9. Install the intermediate parking brake cable upper support bracket bolt (1) and tighten to 25 Nm (18 lb ft).





10. Install the intermediate parking brake cable lower support bracket bolt (1) and tighten to 25 Nm (18 lb ft).





11. Install the intermediate parking brake cable forward bracket bolt (1) and tighten to 25 Nm (18 lb ft).

12. Install the rear suspension support. Refer to Support Replacement Service and Repair.





13. Inspect the O-ring seals on the electronic parking brake control module spindle and the parking brake intermediate cable for damage and correct positioning and replace, if necessary.

Note:
Ensure the park brake intermediate cable fitting is engaged in the actuator in the spindle.

14. Install the parking brake intermediate cable fitting to the spindle.

Note:
When installing the parking brake intermediate cable nut to the electronic park brake module spindle, hold the spindle housing securely to avoid distorting the housing.

15. Connect the parking brake intermediate cable nut (1) to the electronic parking brake control module spindle by rotating the nut clockwise and tighten to 6 Nm (53 lb in).

16. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.

17. Enable the parking brake cable adjuster. Refer to Parking Brake Cable Adjuster Enabling Parking Brake Cable Adjuster Enabling.