C0131

DTC C0131

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC C0131 00

-
ABS Pressure Circuit No Additional Information

DTC C0131 5A

-
ABS Pressure Circuit Plausibility Failure

Circuit/System Description

The electronic brake control module (EBCM) uses input from the brake pressure sensor for more accurate control during a vehicle stability enhancement system (VSES) event.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC

* Pressure signal does not correlate to estimated pressure over time.

* Brake signal does not correlate to pressure signal.

* Signal is erratic and changes faster than physically allowed.

* Brake pedal does not return completely causing residual brake pressure.

Action Taken When the DTC Sets

* The EBCM disables the VSES/TCS for the duration of the ignition cycle.

* A DIC message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for setting the DTC is no longer present.

* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Diagnostic Aids

* Inspect for a binding or obstructed brake pedal or an improperly installed stop lamp switch causing residual brake pressure.

* The pressure sensor is integral to the brake pressure modulator valve (BPMV). The pressure sensor is not serviceable.

Reference Information

Schematic Reference

Antilock Brake System Schematics [1][2]Antilock Brakes / Traction Control Systems

Connector End View Reference

Component Connector End Views 1-2 Shift Solenoid (SS) Valve (MN5)

Description and Operation Reference

ABS Description and Operation Description and Operation

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearning for scan tool information

Circuit/System Verification

1. Apply and release the brake pedal. Verify brake lamps operate properly and the pedal to full return.

• If not within the specified value, refer to Symptoms - Lighting Symptoms - Lighting.

2. Verify DTC C0131 is not set.

• If DTC is set, replace the BPMV and verify DTC does not reset. If DTC resets replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Brake Pressure Modulator Valve Assembly Replacement Brake Pressure Modulator Valve Assembly Replacement

* Control Module References Programming and Relearning for EBCM replacement, setup, and programming.