C0292

DTC C0292

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.

* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0292 1A

-
VSES Combination Sensor Circuits Bias Level Out of Range

DTC C0292 39

-
VSES Combination Sensor Circuits Internal Electronic Failure

Circuit/System Description

The electronic brake control module (EBCM) supplies an ignition voltage to the yaw/lateral accelerometer sensor and monitors the signal circuits back to the EBCM.

Conditions for Running the DTC

Ignition ON

Conditions for Setting the DTC

* An internal failure in the yaw/lateral sensor.

* The yaw/lateral accelerometer sensor bias level are out of range.

Action Taken When the DTC Sets

* The EBCM disables the VSES for the duration of the ignition cycle.

* A driver information center message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.

* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Reference Information

Schematic Reference

Antilock Brake System Schematics [1][2]Antilock Brakes / Traction Control Systems

Connector End View Reference

Component Connector End Views 1-2 Shift Solenoid (SS) Valve (MN5)

Electrical Information Reference

* Circuit Testing Circuit Testing

* Connector Repairs Connector Repairs

* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections

* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearning for scan tool information

Circuit/System Testing

Ignition ON, verify that DTC C0292 is not set.

If DTC is set, replace the yaw/lateral accelerometer sensor. If the DTC resets, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

* Vehicle Yaw Sensor Replacement Service and Repair

* Control Module References Programming and Relearning for EBCM replacement, programming and setup