Transmission Housing Oil Seal Replacement - Rear (RWD)

Transmission Housing Oil Seal Replacement - Rear (RWD)

Tools Required

J 45868 RWD Output Shaft Seal Installer

Removal Procedure

1. Remove the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement One-Piece Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement Two-Piece Propeller Shaft Replacement.




2. Using a suitable tool, pry the rear transmission housing oil seal from the transmission housing.

Installation Procedure




1. Using the J 45868 and a hammer, install the NEW rear transmission housing oil seal.
2. Check the transmission fluid level. Add if necessary. Refer to Transmission Fluid Replacement Transmission Fluid Replacement.
3. Install the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement One-Piece Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement Two-Piece Propeller Shaft Replacement.