Parking Brake Rear Cable Replacement (Left)

Parking Brake Rear Cable Replacement (Left)

Special Tools

J-37043 - Parking Brake Cable Release Tool

Removal Procedure

1. Release the park brake.

2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.





3. Remove the park brake equalizer locknut (1).





4. Using the J-37043 - Parking Brake Cable Release Tool, release the park brake cable from the park brake cable bracket (1) by compressing the locking tabs on the cable conduit (2).

5. Remove the park brake cable from the bracket and the equalizer.





6. Remove the park brake cable bracket bolt (1) from the vehicle underbody.





7. Remove the park brake cable bracket bolt (1) and nut (2) from the lower trailing arm.





8. Disconnect the park brake cable eyelet (1) from the park brake actuator.

9. Using the J-37043 - Parking Brake Cable Release Tool, remove the parking brake cable (2) from the park brake cable bracket.

10. Remove the park brake cable from the cable bracket (2).

Installation Procedure





1. Connect the park brake cable eyelet (1) to the park brake actuator.

2. Install the parking brake cable (2) to the park brake cable bracket.

3. Ensure the locking tabs on the cable conduit are fully engaged to the cable bracket.





Caution:
Refer to Fastener Caution Fastener Caution.

4. Install the park brake cable bracket bolt (1) and nut (2) and tighten to 25 Nm (18 lb ft).

5. Install the park brake cable bracket bolt (1) to the vehicle underbody and tighten to 25 Nm (18 lb ft).





6. Install the park brake cable to the park brake cable bracket (1).

7. Ensure the locking tabs on the cable conduit (2) are fully engaged to the park brake cable bracket.

8. Install the park brake cable to the equalizer.





9. Loosely install the park brake equalizer locknut (1).

10. Adjust the park brake. Refer to Parking Brake Adjustment Adjustments.