Front Side Door Emblem/Nameplate Replacement (Express Access)

Front Side Door Emblem/Nameplate Replacement (Express Access)

Special Tools

J 25070 - Heat Gun

Removal Procedure

Note:
Use the tape for protection and alignment marks for alignment of the new emblem.

1. Apply tape to the area around the door emblem.

2. Heat the emblem/nameplate, using a J 25070 - heat gun 152 mm (6.0 in) from the surface.

3. Apply the heat using a circular motion for about 30 seconds.

Caution:
Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

4. Remove the emblem/nameplate from the door surface using a plastic, flat-bladed tool.





5. Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M(TM) Scotch Brite Molding Adhesive Remover Disk 3M(TM) P/N 07501 or equivalent.

6. Clean the door surface using varnish makers and painters (VMP) naptha.

Installation Procedure





1. If the location of the emblem/nameplate has not been marked, apply tape.

2. Warm the door surface with a J 25070 - heat gun 152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).

Note:
Do not touch the adhesive backing of the emblem/nameplate.

3. Remove the backing from the front end of the emblem/nameplate.

4. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.

5. Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.

6. Inspect the emblem/nameplate for bonding.

7. Remove the tape from the area around the door emblem.