Engine Mount Bracket Replacement - Left Side

Engine Mount Bracket Replacement - Left Side (L96)

Removal Procedure

Caution: When raising or supporting the engine for any reason, do not use a jack under any sheet metal, or the crankshaft pulley, or damage may occur.




1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.

2. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement Upper Intake Manifold Sight Shield Replacement.

3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

4. Remove the left wheel house liner. Refer to Front Wheelhouse Liner Replacement - Left Side .

5. Remove the engine mount to engine mount bracket bolts (1).

6. Position an adjustable jack and a block of wood under the engine oil pan.

7. Raise the engine slightly.




8. Remove the engine mount bracket through bolts.

9. Remove the engine mount bracket.

Installation Procedure




1. Position the engine mount bracket onto the frame.

2. Clean the threads of the engine mount bracket through bolts using denatured alcohol or equivalent.

3. Apply threadlocker or equivalent to the threads of the engine mount bracket through bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers Adhesives, Fluids, Lubricants, and Sealers.

Caution: Refer to Fastener Caution Fastener Caution.

4. Install the engine mount bracket through bolts and tighten to 100 Nm (74 lb ft).

5. Using the adjustable jack, lower the engine until the engine mounts are sitting flush on the engine mount brackets.

6. Remove the adjustable jack and block of wood from the engine oil pan.




7. Clean the threads of the engine mount to engine mount bracket bolts using denatured alcohol or equivalent.

8. Apply threadlocker or equivalent to the threads of the engine mount to engine mount bracket bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers Adhesives, Fluids, Lubricants, and Sealers.

9. Install the engine mount to engine mount bracket bolts and tighten to 65 Nm (48 lb ft).

10. Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .

11. Lower the vehicle.

12. Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement Upper Intake Manifold Sight Shield Replacement.

13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection Battery Negative Cable Disconnection and Connection.