Engine Mount Replacement - Left Side

Engine Mount Replacement - Left Side (L96)

Removal Procedure

Caution:
When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.

1. Remove the left engine mount bracket. Refer to Engine Mount Bracket Replacement - Left Side (L96) Engine Mount Bracket Replacement - Left Side.




2. Working through the wheelhouse opening, remove the engine mount to engine block bolts (1).

3. Using the adjustable jack, raise the engine slightly until there is enough clearance to remove the engine mount.




4. Remove the engine mount through the rear of the wheel well opening.

Installation Procedure




1. Position the engine mount to the engine block.





Caution: Refer to Fastener Caution Fastener Caution.

2. Working through the wheelhouse opening, install the engine mount to engine block bolts (1) and tighten to 50 Nm (37 lb ft).

3. Install the engine mount bracket. Refer to Engine Mount Bracket Replacement - Left Side (L96) Engine Mount Bracket Replacement - Left Side.