Windshield Washer Pump: Service and Repair

REMOVAL

Negative Battery Cable Remote Terminal:

1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Hoist vehicle.
3. Remove front fascia as necessary (left side only and use a 2x4 to prop left edge of fascia away from body).
4. Disconnect the wire connectors from the reservoir pump.

Wiper Motor Retaining Bolts:

5. Gently pry pump away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
6. Remove rubber grommet from reservoir and throw away.

INSTALLATION
- For installation, reverse the above procedures. Use new rubber grommet with new pump. Assure pump is fully seated into reservoir.

NOTE: Replace/refill washer fluid after reservoir pump replacement.