Transmission Mount: Service and Repair

REMOVAL AND INSTALLATION

CAUTION: Mounting locations marked by should be provisionally tightened, and then fully tightened after placing the vehicle horizontally and loading the full weight of the engine on the vehicle body.

Removal Service Point
<> Transaxle Mount Bracket Removal

1. Install special tools MB991453 and MZ203827 to the vehicle body to support the engine and transaxle assembly.
2. Remove the center member and rear roll stopper bracket.
3. Remove the bolt and nut of the transaxle mount bracket.
4. After lowering the engine and transaxle assembly, remove the transaxle mount bracket.

Installation Service Point
>>A<< Transaxle Mount Stopper Installation

Clamp the transaxle mount stopper so that the arrow points in the direction as shown in the diagram.