1000 - 1999: 1910

1910-00 SLA SYSTEM OVERVOLTAGE









For a complete Shift Lever Assembly Circuit Diagram, [1][2]Automatic Transmission/Transaxle.

Diagnostic Test

1. ENGINE CHARGING SYSTEM DTCS PRESENT
Turn the ignition on.
With the scan tool, read the engine DTCs.
Are any Engine Charging System DTCs present?

Yes

- Diagnose and repair the DTC(s).

No

Go To 2

2. FUSED IGNITION SWITCH OUTPUT OR TRACTION SYSTEM RELAY OUTPUT CIRCUITS OVERVOLTAGE




Turn the ignition off.
Disconnect the Shift Lever Assembly harness connector.

NOTE: Check connectors - Clean/repair as necessary.

Start the engine and raise the engine speed to 1500 RPM.
Measure the voltage of the Fused Ignition Switch Output and Traction System Relay Output circuits at the SLA harness connector.
Is the voltage above 16.0 volts ± 0.3 volt?

Yes

- Repair the Fused Ignition Switch Output and Traction System Relay Output circuits for an overvoltage condition.
- Perform NAG1 TRANSMISSION VERIFICATION TEST. Transmission Verification Test

No

- Replace the Shift Lever Assembly. Manual Transmission/Transaxle - Removal.
- Perform NAG1 TRANSMISSION VERIFICATION TEST. Transmission Verification Test