8000 - 8999: 8004

8004 - TIRE PRESSURE SENSOR/TRANSMITTER FAILURE





When Monitored and Set Condition

- When Monitored: With the ignition ON, the Tire Pressure Monitor (TPM) module monitors the signal transmitted from each of the Tire Pressure Sensors.
- Set Condition: If the Tire Pressure Monitor (TPM) module detects a loss of a Tire Pressure Sensor signal from one or more of the Tire Pressure Sensors, this DTC will be set.





For a complete Tire Pressure Monitor Circuit Diagram Schematics and Diagrams.

Diagnostic Test

1. READING TPM DIAGNOSTIC TROUBLE CODES
NOTE: DTC 8004 will always be set in conjunction with one or more of the Tire Pressure Sensor/Transmitter Failure DTCs. Either 8017 (LF Tire), 8018 (RF Tire), 8019 (RR Tire), or 8020 (RF Tire) will be set along with the 8004 code.

NOTE: The Tire Pressure Sensor/Transmitters can set this DTC if the vehicle is sitting still for a prolonged period of time and the key is ON. The Tire Pressure Sensor/Transmitter must be tested properly prior to replacement.

Turn the ignition on.
With the scan tool, read and record the TPM DTCs.
Refer to the appropriate Tire Pressure Sensor/Transmitter Failure DTC for proper diagnostic and repair procedures.

Tire Pressure Sensor/Transmitter Failure DTC List:
- 8017 - Left Front Tire Pressure Sensor/Transmitter Failure

- 8018 - Right Front Tire Pressure Sensor/Transmitter Failure

- 8019 - Right Rear Tire Pressure Sensor/Transmitter Failure

- 8020 - Left Rear Tire Pressure Sensor/Transmitter Failure

Are any of the above DTCs active along with 8002?

Yes

- Perform the diagnostics for the active DTCs.

No

- Test complete. Check for any TSBs that may apply.