Washer Nozzle - Installation

INSTALLATION





1. Install the washer nozzle (1) into the cowl grille (2). Press downward with a rocking motion until the retaining clip is fully seated.




2. Slide the washer hose clamps (1) onto the washer hose (2).
3. Install the washer hose (2) over the washer nozzle (3).
4. Tighten the washer clamps (1) onto the washer nozzle (3) allowing approximately 0.78 inch (20 mm) clearance between the washer hoses.




NOTE: If the main washer nozzle harness connector (1) was disconnected, reconnect at this time.

5. Connect the washer nozzle harness connector (2).




6. Connect the washer nozzle harness connector (s) (1-2) to the thermoswitch. Install the thermoswitch into the cowl grill.
7. Install the cowl grille. Cowl Moulding / Trim.