Right Rear Cable Replacement

REMOVAL
1. Raise vehicle on jackstands or centered on a hoist.
2. Remove rear tire and wheel assembly.
3. Remove rear brake drum from the rear wheel of the vehicle requiring service to the rear park brake cable.

Locking Out Automatic Adjuster:

4. Create slack in the rear parking brake cables by locking out the automatic adjuster as described. Grasp exposed section of front parking brake cable and pull down on it. Then install a pair of locking pliers on the cable just rearward of the second body outrigger bracket.

Intermediate Cable Attachment To Right Rear Cable:

5. Disconnect the right rear parking brake cable from the connector on the intermediate cable.

Right Park Brake Cable Removal From Body Bracket:

6. To remove the right parking brake cable housing from the body bracket, slide a 14 mm box end wrench over the end of cable retainer to compress the retaining fingers. The alternate method using an aircraft type hose clamp will not work on the right side of the vehicle.
7. Remove the brake shoes from the brake support plate. Refer to Drum Brake System Brake Shoe Service and Repair Removal for the required procedure. Service and Repair
8. Disconnect parking brake cable from parking brake actuator lever.

Removing Park Brake Cable From Brake Support Plate:

9. Remove the parking brake cable housing retainer from the brake support plate using a 14mm wrench to compress the retaining fingers.

INSTALLATION
1. Install the parking brake cable in the brake support plate. Insert cable housing retainer into brake support plate making certain that cable housing retainer fingers lock the housing and retainer firmly into place.
2. Attach the parking brake cable onto the parking brake actuator lever.
3. Install the brake shoes on the rear brake support plate.
4. Insert cable housing retainer into body bracket making certain that cable housing retainer fingers lock the housing firmly into place.
5. Connect the right rear parking brake cable to the connector on the intermediate parking brake cable.
6. Install the brake drum, and the wheel and tire assembly.
7. Remove the locking pliers from the front parking brake cable. This will automatically adjust the parking brake cables.
8. Apply and release parking brake pedal 1 time, this will seat the parking brake cables.