Power Steering Pump Removal and Installation

Fig. 8 Exploded View Of Power Steering Pump Component Locations. SOHC:

Fig. 9 Exploded View Of Power Steering Pump Component Locations. DOHC:

FRONT

1. Drain power steering fluid from system.
2. Remove power steering pump drive belt.
3. Remove right front timing belt cover.
4. Remove timing belt cover cap.
5. Remove left front timing belt cover.
6. Remove power steering pump pressure hoses.
7. Remove timing belt and camshaft sprocket, refer to Engine/Camshaft, Lifters and Push Rods/Camshaft Oil Seal/Service and Repair.
8. Remove power steering retaining bolts, then pump.
9. Reverse procedure to install, noting the following:
a. Bleed power steering system.
b. Adjust drive belt tension.
c. Torque all bolts to specification.

Fig. 10 Rear Power Steering Oil Pump Removal:

REAR

1. Drain power steering fluid into a suitable container.
2. Remove main muffler assembly.
3. Remove rear power steering pump in numbered sequence shown, noting the following:
a. Support differential case using a suitable transmission jack, then remove crossmember bracket and crossmember mounting nuts on the differential side.
b. Slightly lower crossmember assembly, then remove pump assembly.
4. Reverse procedure to install, noting the following:
a. Bleed power steering system, refer to Steering and Suspension/Steering/Power Steering Pump/Service and Repair.