Parking Brake Lever Installation

WARNING: THE AUTO ADJUSTING FEATURE OF THIS PARKING BRAKE LEVER ASSEMBLY CONTAINS A CLOCK SPRING LOADED TO APPROXIMATELY 20 POUNDS. DO NOT RELEASE THE AUTO ADJUSTER LOCKOUT DEVICE BEFORE INSTALLING CABLES INTO THE EQUALIZER. KEEP HANDS OUT OF AUTO ADJUSTER SECTOR AND PAWL AREA. FAILURE TO OBSERVE CAUTION IN HANDLING THIS MECHANISM COULD LEAD TO SERIOUS INJURY.

PROCEDURE

Park Brake Lever Attachment To Console Bracket:

1. Place park brake lever on console bracket. Install and securely tighten the 2 attaching nuts.

Park Brake Cables At Equalizer:

2. Install both rear park brake cables into equalizer on park brake lever output cable.
3. Ensure that park brake cable is correctly installed and aligned with cable track on park brake lever.

Removing Lockout Pin From Park Brake Lever:

4. Firmly grasp park brake lever locking pin and quickly remove it from the park brake lever mechanism. This will allow the park brake lever mechanism to correctly adjust the park brake cables.

Brake Warning Lamp Connection To Park Brake Lever:

5. Connect electrical connector for brake warning lamp onto terminal on park brake lever assembly.
6. Cycle park brake lever once to position park brake cables. Then return the park brake lever its released position. Check the rear wheels of the vehicle. They should rotate freely without dragging.
7. Raise park brake lever to its fully engaged position. This is necessary to allow installation of the center console.
8. Install center console assembly

Attaching Screws At Rear Of Center Console With Out Arm Rest:

Attaching Screws At Rear Of Center Console With Arm Rest:

Attaching Screws At Front Of Center Console:

9. Install the 4 center console assembly attaching screws.