Fluid Level Check

STANDARD PROCEDURE - FLUID LEVEL CHECK

NOTE: For proper fluid level check intervals, Refer to MAINTENANCE SCHEDULES.

The fluid required in this transaxle is Mopars ATF+4. Use of substitute fluids may result in improper transaxle operation and/or failure.

1. Raise vehicle on hoist.





2. Remove transaxle fill plug Fig. 118).
3. Inspect fluid level. Fluid should be within 3/16" below fill hole. Add Mopars ATF+4 as necessary.
4. Install fill plug, ensuring it is properly seated.
5. Lower vehicle.