Rear Center Seat Belt Retractor - Installation

INSTALLATION





1. Position rear center seatbelt retractor into hollow in the D-pillar (3).
2. Install the rear center seatbelt retractor retaining bolt (5). Tighten bolt to 40 Nm (29.5 ft. lbs.).
3. Feed seatbelt webbing through upper C-pillar trim panel.
4. Install the upper C-pillar trim panel C-Pillar Trim Panel-Installation.




5. If replacing the seatbelt into the latch stowage, place into slot and push down.




6. If latching seatbelt (1) to anchor (2), attach Quick Connect Anchor (2).