Pressure Hose - Right-Hand-Drive

RIGHT-HAND-DRIVE

1. Install pressure hose in engine compartment from underneath.

NOTE: Always use a NEW O-ring on the end of the pressure hose.

2. Lubricate NEW O-ring on steering gear end of pressure hose with clean power steering fluid.




3. Install gear end of pressure hose (5) into steering gear port. Do not tighten tube nut at this time.
4. Route pressure hose along left side of engine cradle. Position pressure hose routing clamp, then install screw (7) through clamp, securing hose to left side of engine cradle.
5. Route pressure hose along front of engine cradle. Install screw (2) through routing clamp securing hose to front of engine cradle.
6. Tighten pressure hose tube nut (5) at steering gear to 47 Nm (35 ft. lbs.).
7. Install belly pan. Belly Pan - Installation
8. Lower vehicle.

NOTE: Always use a NEW O-ring on the end of the pressure hose.

9. Lubricate NEW O-ring on power steering pump end of pressure hose with clean power steering fluid.




10. 2.7L/3.5L Engines - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.).




11. 5.7L/6.1L Engines - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.).




12. 3.0L Diesel Engine - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.).
13. Install air cleaner housing and inlet tube. Air Cleaner Housing - Installation




14. Connect battery negative cable (2) to battery post. It is important that this is performed properly. Battery Reconnection
15. Fill and bleed power steering system. Service and Repair