Left

LEFT





1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gaskets (1)AND(2) as necessary.





2. Install cylinder head cover and hand start all fasteners. Verify that all double-ended studs are in the correct locations.
3. Tighten cylinder head cover attaching bolts and double-ended studs to 12 Nm (105 in. lbs.).





4. Install ignition coils (1).





5. Install ignition coil capacitor (2) and fastener.
6. Install ground strap (1) to cylinder head cover stud.
7. Connect all electrical connectors and harness clips.
8. Connect make up air hose.
9. Install upper intake manifold Intake Manifold - Installation.





10. Connect negative battery (1) cable.