Right

RIGHT





1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gaskets (1)AND(2) as necessary.





2. Install cylinder head cover and hand start all fasteners. Verify that all double-ended studs are in the correct locations.
3. Tighten cylinder head cover attaching bolts and double-ended studs to 12 Nm (105 in. lbs.).





4. Install ignition coils (1).





5. Install ignition coil capacitor (2) and fastener.
6. Connect ground strap (1) to cylinder head cover stud.
7. Connect PCV hose to cylinder head cover grommet.
8. Connect all electrical connectors and harness clips.





9. Install foam insulator (1) on top of cylinder head cover (2).
10. Install upper intake manifold Intake Manifold - Installation.





11. Connect negative battery (1) cable.