Removal

REMOVAL





1. Release the fuel pressure, refer to the Fuel Pressure Release Procedure. Service and Repair
2. Disconnect negative battery cable from battery (1).






CAUTION: The fuel level of the vehicle must be below 5/8 of a tank before you remove the module lock-rings. If the fuel level is above 5/8 of a tank, fuel can spill into the vehicle.

3. Partially drain the tank through the filler tube. Use a hard nylon tube with a 30° cut on the end to push past the check valve.





4. Remove the rear lower seat cushion.





5. Fold back the foam pad cover to access the module covers (1).
6. Remove plastic access covers (1) from floor pan.





7. Disconnect the fuel supply line (2) from module (1).
8. Mark the module orientation.





9. Use SAE fuel pump lock ring wrench 9340 (1) to remove right side module lock ring (2).





10. Lift module up enough to push hose (1) into tank and drain. Do not spill fuel in interior of vehicle.





11. Pull module up and out of fuel tank.





12. Fuel Pressure regulator location.
13. Remove ground wire.





14. Use a screwdriver and pry up on retaining clip.





15. Remove the fuel pressure regulator retaining clip (1).





16. Remove fuel pressure regulator (1).





17. Remove o-ring (1) from module.