Seat Belt Retractor - Installation

INSTALLATION

FRONT





1. Position the retractor in the B-pillar (1) with the indexing tabs (2).
2. Install the one front seat belt retractor (4) retaining bolt (3). Torque bolt to 32 Nm (24 ft. lbs.).
3. Install the one screw between the upper retractor indexing tabs (2) in B-pillar.





4. Connect the tensioner (2) squib connector (3).





5. Install the one screw (2) to the front seat belt web guide (3). Torque screw to 3 Nm (20 in. lbs.).





6. Position the upper turning loop (3) and install the retaining bolt (4). Torque bolt to 40 Nm (30 ft. lbs.).
7. Install the upper turning loop (3) trim cover (2).





8. Install the lower B-pillar trim B-Pillar Trim Panel-Installation.





9. Position the seat belt (1) onto the stud on the seat cushion frame and install the lower anchor nut (2). Torque nut to 37 Nm (27 ft. lbs.).
10. Install the trim cover (3) onto the seat cushion outboard trim cover.

WARNING: Do not connect the battery negative cable Component Tests and General Diagnostics . Personal injury or death may result if the system test is not performed first.


REAR - SEDAN





1. Position the retractor (4) on the C-pillar to the indexing tab slips up into the pillar.
2. Install the retractor mounting bolt (3). Torque bolt to 32 Nm (24 ft. lbs.).





3. Install the one upper turning loop retaining bolt (2). Torque bolt to 40 Nm (30 ft. lbs.).





4. Install the upper C-pillar trim panel C-Pillar Trim Panel-Installation.





5. Install the lower seat belt anchor (2) bolt (3). Torque bolt to 32 Nm (24 ft. lbs.).

REAR - WAGON





1. Place the one rear seat belt retractor (4) so that the indexing tab is in its slot.
2. Install the retaining nut (2). Torque nut to 34 Nm (25 ft. lbs.).
3. Install the quarter trim panel.





4. Install the lower seat belt anchor (2) bolt (3). Torque bolt to 32 Nm (24 ft. lbs.).

REAR CENTER - SEDAN





1. Place the rear center retractor (2) into position and install the one retaining nut (1). Torque nut to 34 Nm (25 ft. lbs.).





2. Install the rear shelf trim panel Rear Shelf Panel - Installation.





3. Install the one nut (3) to the seat belt lower anchor. Torque nut to 34 Nm (25 ft. lbs.).
4. Install the rear seat cushion Seat Cushion Cover - Installation.

REAR CENTER - WAGON





1. Position the rear center retractor into position in the seat back.
2. Install the one bolt (2) holding the rear center seat belt retractor. Torque nut to 34 Nm (25 ft. lbs.).
3. Install the left seat back trim cover (60% portion of the rear folding seats) Seat - Installation.