Headlamp Washer Pump Motor - Removal

REMOVAL





1. Disconnect and isolate the battery negative cable.
2. Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose from the front (outboard) washer pump and allowing the washer fluid to drain into a container through a temporary jumper hose connected to the front washer pump.
3. Remove the washer reservoir Windshield Washer Reservoir - Removal.
4. Disconnect the high pressure headlamp washer pump hose by pressing down firmly on latch and pulling hose off.
5. Disconnect the high pressure headlamp washer pump motor electrical connector (1).
6. Remove pump from reservoir by pulling pump up and away from reservoir cavity and out of mounting grommet. Do not damage reservoir/pump sealing surface or puncture reservoir during removal.
7. Remove pump grommet and discard.