Vibration Damper - Installation

INSTALLATION










1. Install the crankshaft damper using the 5.9 inch long Forcing Screw C-4685-C1 (2) with Nut and Thrust Bearing from Crank Sprocket Installer 6792 (1).





2. Install the crankshaft damper bolt (3). Tighten the bolt to 95 Nm (70 ft. lbs.) while holding the damper (1) with Damper Holding Fixture 9365 (2).










3. Install the accessory drive belt (6) Serpentine Accessory Drive Belt - Installation.










4. Position the radiator cooling fan assembly (1) in the vehicle.
5. Install the cooling fan mounting bolts. Tighten the bolts to 6 Nm (50 in. lbs.).
6. Connect the cooling fan electrical connector (2).
7. Install the upper radiator hose (3).
8. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
9. Fill the cooling system Service and Repair.
10. Operate the engine until it reaches normal operating temperature. Check the cooling system for correct fluid level Service and Repair