U0127

U0127-LOST COMMUNICATION WITH TIRE PRESSURE MONITOR MODULE





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on.

Battery voltage between 10 and 16 volts.

Ignition Off Draw (IOD) fused installed.

Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
Bus messages not received from the Tire Pressure Monitor Module (TPM) for approximately 500 ms.





1. VERIFY DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE

NOTE: Make sure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.

1. With the scan tool, read active DTCs.

Is this DTC active?

Yes

- Go To 2

No

- Stored Lost Communication DTCs Perform the Stored Lost Communication DTCs diagnostic procedure.

2. CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCS
1. With the scan tool, read all active DTCs from all modules.

NOTE: Check for TIPM configuration, CAN B or C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.

Does the scan tool display any active DTCs to the conditions listed above?

Yes

- Go To and perform the appropriate diagnostic procedure.

No

- Go To 3

3. VERIFY THE TPM IS ACTIVE ON THE BUS
1. Turn the ignition on.
2. With the scan tool, select ECU View.
3. Verify the TPM is active on the bus.

Is the TPM active on the bus?

Yes

- Go To 4

No

- No Response From TPM (Tire Pressure Monitor Module) Perform the No Response from TPM diagnostic procedure.

4. CHECK FOR ADDITIONAL COMMUNICATION RELATED DTCS
1. With the scan tool, select Network View and select Advanced.

Is there more than one module with active DTCs "Logged Against" the TPM?

Yes

- Replace/update the Tire Pressure Monitor Module.
- Perform the TPM VERIFICATION TEST. Tire Pressure Monitor (TPM) Verification Test.

No

- Replace/update the module that set this DTC
- Perform the appropriate verification test. Verification Tests