U1415

U1415-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA

For a complete wiring diagram, refer to the Wiring Information.

Theory of Operation
When powered, the Occupant Restraint Controller (ORC) performs an internal self test. The repair of this fault does not involve any external circuitry and centers on verifying that the module is configured correctly for the vehicle's restraint system components.
- When Monitored:
With the ignition on. The ORC on board diagnostics loads the ORC Configuration Data from the TIPM CAN Bus message.

- Set Condition:
This DTC will set if the CAN Bus message was received but the information is invalid or corrupt.





Always Perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.
OCCUPANT RESTRAINT CONTROLLER (ORC)

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

WARNING: If the Occupant Restraint Controller is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.

1. Disconnect the ORC harness connector(s).

NOTE: Check connectors - Clean and repair as necessary.

Repair

- Replace the Occupant Restraint Controller (ORC). Occupant Restraint Controller - Removal
- Perform RESTRAINTS SYSTEM VERIFICATION TEST. Restraints System Verification Test.