A/C And Heater Control - Installation

INSTALLATION





1. Position the A/C-heater control (2) into the instrument panel center bezel (3).
2. Install the four screws (1) that secure the A/C-heater control to the instrument panel center bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the instrument panel center bezel Instrument Panel Bezel - Installation.

NOTE: The A/C-heater control automatically performs the Actuator Calibration function when the ignition is initially turned on when installing a new control or reinstalling the original control. However, the Actuator Calibration function must be manually initiated using a scan tool if the A/C-heater control has been previously installed in another vehicle.

4. Reconnect the negative battery cable.
5. Initiate the Actuator Calibration function using a scan tool . HVAC System Test