B161B

B161B-COURTESY/DOME LAMP CONTROL CIRCUIT LOW





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on.

- Set Condition:
The Cluster detects a Short to Ground on the (M24) Courtesy Lamps Driver circuit.





1. CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
1. Turn the ignition on.
2. With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. (M24) COURTESY LAMPS DRIVER CIRCUIT SHORT TO GROUND




1. Turn the ignition on.
2. Disconnect the Cluster C3 connector.
3. Measure the resistance of the (M24) Courtesy Lamp Driver circuit to ground.

Is the resistance below 5.0 Ohms?

Yes

- Repair the (M24) Courtesy lamp Driver circuit for a short to ground.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Cluster.
- Perform the BODY VERIFICATION TEST. Body Verification Test.