Passive Entry Module (PEM)

B2199-17-BATTERY VOLTAGE - CIRCUIT VOLTAGE ABOVE THRESHOLD





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
At all times.

- Set Condition:
This Diagnostic Trouble Code (DTC) sets any time the module senses voltage input above 16.0 Volts for over 20ms, this code will set.





1. CHECK ENGINE DTCs
1. Using the scan tool, read the active ENGINE DTCs.

Are there any ENGINE Charging or Battery DTCs present?

No

- Go To 2

Yes

- Testing and Inspection Perform the appropriate diagnostic procedure.

2. TEST FOR INTERMITTENT CONDITION
1. Using the scan tool, record and erase the DTCs
2. Start the engine and let it run for two minutes.
3. Using the scan tool, read the active DTCs.

Does the scan tool display B2199-17-BATTERY VOLTAGE - CIRCUIT VOLTAGE ABOVE THRESHOLD?

Yes

- Replace the Passive Entry Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST. Body Verification Test.