Occupant Restraint Controller (ORC)

B222A-VEHICLE LINE MISMATCH

For a complete wiring diagram, refer to the Wiring Information.

Theory of Operation
When powered, the Occupant Restraint Controller (ORC) performs an internal self test. The repair of this fault centers on verifying the ORC programmed and vehicle content configuration.
- When Monitored:
The ORC checks its feature configuration for a stored Vehicle Line and Country Code continuously 3 seconds after initialization based on 6 samples.

- Set Condition:
This DTC sets when the ORC detects a mismatch between the Vehicle Configuration and the ORC configuration.





Always Perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.
REPLACE OCCUPANT RESTRAINT CONTROLLER (ORC)
1. Turn the ignition on.
2. With the scan tool, erase and read ORC DTCs.

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

WARNING: If the Occupant Restraint Controller is dropped at any time, it must be replaced. Failure to take proper precautions can result in accidental airbag deployment and serious or fatal injury.

When this code is set, view repair.

Repair

- Replace the Occupant Restraint Controller (ORC).
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST Restraints System Verification Test.