U0139

U0139-LOST COMMUNICATION WITH ACTIVE DAMPING CONTROL MODULE (ADCM)

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
With the ignition on.

Battery voltage between 10 and 16 volts.

Ignition Off Draw (IOD) fuse installed.

Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
Bus messages not received from the Active Damping Control Module (ADCM) for approximately two to five seconds.





Diagnostic Test

1. VERIFY DTC IS ACTIVE

NOTE: Make sure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.

1. With the scan tool, read active DTCs.

Is this DTC active?

Yes
- Go To 2

No
- Stored Lost Communication DTCs and perform the Stored Lost Communication DTCs diagnostic procedure.

2. CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCS
1. With the scan tool, read all active DTCs from all modules.

NOTE: Check for TIPM configuration, CAN B or C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.

Does the scan tool display any active DTCs to the conditions listed above?

Yes
- Perform the appropriate diagnostic procedure.

No
- Go To 3

3. VERIFY THE ADCM IS ACTIVE ON THE BUS
1. Turn the ignition on.
2. With the scan tool, view all the modules.
3. Verify the ADCM is active on the bus.

Is the ADCM active on the bus?

Yes
- Go To 4

No
- No Response From ADCM (Active Damping Control Module) and perform the No Response from ADCM diagnostic procedure.

4. CHECK FOR ADDITIONAL COMMUNICATION RELATED DTCS
1. With the scan tool, view all the modules.

Is there more than one module with active DTCs "Logged Against" the ADCM?

Yes
- Replace/update the ADCM module.
- Perform the ADCM VERIFICATION TEST. .

No
- Replace/update the module that set this DTC.
- Perform the appropriate verification test.