Instrument Cluster - Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, Occupant Classification System (OCS), seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to follow these instructions may result in accidental airbag deployment.

CLUSTER ASSEMBLY





1. Position the cluster assembly (1) into the instrument panel opening.
2. Connect the cluster electrical connectors.
3. Install the cluster retaining screws (3).
4. Install the cluster bezel Instrument Cluster Bezel - Installation.
5. Connect the battery negative cable.

CLUSTER LENS, AND HOOD AND MASK ASSEMBLY





1. Place cluster lens into position on cluster.
2. Install the cluster lens retaining screws.
3. Install the cluster into the instrument panel. 1