Pressure Hose

NON SRT





1. Install pressure hose in engine compartment from underneath.

NOTE: Always use a NEW O-ring on the end of the pressure hose.

2. Lubricate new O-ring on steering gear end of pressure hose with clean power steering fluid.
3. Install pressure hose (2) to steering gear (1). Do not tighten tube nut at this time.





4. Route pressure hose (4) along right side of engine cradle as shown and install retaining bolt (3). Tighten bolt to 19 Nm (14 ft. lbs.).






NOTE: Always use a new O-ring on the end of the pressure line.

5. Lubricate the new O-ring on the end of the pressure line with clean power steering fluid.
6. Install power steering pressure line to Electro Hydraulic Power Steering (EHPS) Pump (3).
7. Install pressure line retaining bolt (2) and tighten to 10 Nm (89 in. lbs.).





8. Tighten pressure hose tube nut at steering gear to 47 Nm (35 ft. lbs.).





9. Connect negative battery cable (2) to battery post. It is important that this is performed properly.
10. Fill and bleed power steering system Service and Repair
11. Install right front wheel house splash shield Splash Shield - Installation
12. Lower vehicle.