Rear Suspension Spring Link - Removal

NON SRT

Special Tools:










1.
Raise and support vehicle

2.
Access and remove rear spring

3.
If servicing right spring link, disconnect headlamp leveling sensor (1) link at spring link (3), if equipped.





4.
Remove spring link-to-knuckle nut and bolt (2).





CAUTION:
It important to use (2) when tapping sleeve in knuckle to help keep (1) straight during use or damage to Tap may occur.

5.
Place Guide (9361-2)(2) against sleeve (3) in knuckle to keep (9361-1) (1) straight. Using Tap with an appropriate handle, cut threads approximately halfway through bushing (or about six complete threads). It is important to back tap out, clean out burrs and lubricate Tap often during process.





NOTE:
Prior to using (9361A), lubricate Bolt (1) threads to provide ease of use and promote tool longevity.

NOTE:
When installing thrust bearing on Remover, be sure to place hardened side against nut. Place bearing outer cage against stationary component.

6.
Assemble (9361A) as shown.
(1) (9361-3)

(2) Nut

(3) Spherical Washer

(4) Thrust Bearing

(5) (9361-4)





7.
Thread (9361-3) (1) into tapped knuckle sleeve.

8.
Rotate Nut down, matching Sleeve angled end with angled face of knuckle.

9.
Continue to rotate Nut until knuckle sleeve is removed from knuckle. Discard knuckle sleeve; replace it with new upon installation.




10.
Remove bolt and nut (1) fastening spring link (4) to crossmember.
11.
Remove spring link (4).