Wiper Motor - Installation

INSTALLATION

NOTE: When installing the motor onto the linkage assembly, do not remove the bellcrank. A timing issue will arise with the cam in the motor and a new motor will be needed. The wiper motor will be shipped from Mopar(R) with the bellcrank already installed.





1. Ensure that the pocket nuts (1) are in place in the motor before assembly.
2. If needed to install pocket nut (1), align the nut with the pocket.





3. Drop nut (1) into pocket.
4. Place wiper motor in its mounting location making sure that the pocket nuts are in place.
5. Install and tighten the mounting bolts (1).
6. Snap the wiper linkage on the ball on the bellcrank. Make sure to use Mopar(R) approved grease when installing.





7. Install the front wiper module (3) Wiper Arm Linkage - Installation.
8. Connect the negative battery cable.