Wiper Motor - Removal

REMOVAL





1. Disconnect and isolate the negative battery cable.
2. Remove the front wiper module (3) Wiper Arm Linkage - Removal.

NOTE: When removing the motor from the linkage assembly, do not remove the bellcrank nut. A timing issue will arise with the cam in the motor and a new motor will be needed. The wiper motor will be shipped from Mopar(R) with the bellcrank already installed.

3. With the front wiper module on bench or in vise, remove the linkage using a screwdriver, flat bar, or equivalent to pry the linkage off the bellcrank.
4. Remove the two motor mounting bolts (1).

NOTE: When separating the motor from the linkage, there are two pocket nuts that may fall out. Take care to keep these and reinstall them during installation.

5. Separate the wiper motor from the wiper module/linkage.