Front

REMOVAL

Special Tools:










1. Disconnect the negative battery cable (1).
2. Remove the intake manifold Intake Manifold - Removal.






NOTE: The Oil Control Valve (OCV) (3) is located under the intake manifold.

3. Disconnect OCV electrical connector (1).
4. Remove OCV retaining bolt (2).






NOTE: To remove the OCV, the engine must be at room temperature.

5. While rotating the OCV back and forth to break the seal, remove the OCV.
6. Remove the engine oil dipstick tube retaining nut at the right exhaust manifold and remove the dipstick tube.
7. Raise and support the vehicle.





8. Remove the belly pan retainers (1) and remove the belly pan.





9. Remove the generator support bracket to engine mount retaining nut (1).
10. Remove the generator support bracket retaining bolt (2) and remove the support bracket (3).
11. Lower the vehicle.






NOTE: Left side shown, right side similar.

12. Remove both left/right engine mount heat shield (4) retaining nuts (3) and remove the heat shields
13. Remove both left/right engine mount to frame retaining bolts (2).






NOTE: Do not use air tools to install the engine lift fixture.

14. Install the Engine Lift Fixture (1), Engine Lift Adapter (2) and the Engine Support Fixture (3).
15. Raise the engine to provide clearance to remove the engine mounts.






NOTE: Left side shown, right side similar.

16. Remove both left/right engine mount retaining bolts (1) and remove the engine mounts (2).






NOTE: Left side shown, right side similar.

17. If required, remove the engine mount to engine block mounting bracket(s) retaining bolts (1) and remove the mounting bracket(s) (2).