Vehicles For USA

AUTOMATIC SEAT BELT MOTOR RELAY INSPECTION
1. Remove the automatic seat belt motor relay.





2. Check for continuity between terminals under the conditions described in the chart above.





MOTOR, RELEASE SWITCH AND FASTEN SWITCH
1. Disconnect the automatic seat belt motor relay connector.





2. Connect the battery to the connector (shown in the figure) at the automatic seat belt motor relay harness side, and, as shown in the table below, check to be sure that the slide anchor functions normally, and also check for continuity of each switch.

CAUTION: The slide anchor must be activated all the way to the fasten position or the release position, without stopping part way on the guide rail.

NOTES:
1. (+)----(-) indicates terminals to which battery voltage is applied.
2. ()----() indicates that there is continuity between the terminals.





OUTER SWITCH
1. Disconnect the outer switch connector.





2. Check for continuity between terminals when the shoulder belt is pulled out approximately 700 mm (28 in.) or more.






DOOR LATCH SWITCH





Operate the switch and check the continuity between the terminals as indicated in the chart.





BUCKLE SWITCH
1. Disconnect the buckle switch connector (L.H. only)





2. Check the continuity between the terminals as indicated in the chart.





BUZZER
1. Apply the battery voltage between the terminals 2, 6, and 10.
2. Confirm that the buzzer sounds when the terminal 9 is grounded.