12 DTC 43 Is Retrieved

1. Turn the ignition key to the "LOCK" position, disconnect the negative battery cable and tape the terminal.

Caution

Wait at least 60 seconds after disconnecting the battery cable before doing any further work.

2. Remove the floor console assembly.

3. Place a flat-tipped screwdriver against the lock spring at the lock lever notch and push the spring toward the unit.

Caution

Do not use excessive force to raise the lock lever.

4. Disconnect the red 14-pin connector from the SRS-ECU.










5. Connect the now disconnected red harness-side SRS- ECU con ne~or (14-pin) to the connector 3 of the SRS Check Harness.

6. Check according to the flow chart below, using the specified digital multi-meter.

NOTE-IMPORTANT

1. After repairing the SRS, reconnect the battery cable and check the SRS warning light operation to verify the system functions properly. (Refer to TEST 2. )

2. SRS-ECU = SRS Air Bag Control Unit