Front

Fig. 14 Stabilizer Bar Removal:

Fig. 15 Stabilizer Ball Joint Starting Torque Inspection:

STABILIZER BAR REPLACE
1. Remove propeller shaft from vehicle.
2. Remove stabilizer bar in sequence as shown. When disconnecting front exhaust pipe assembly and exhaust manifold, take care not to bend flexible joint.
3. Check ball joint starting torque. Starting torque should be 15-28 inch lbs.

Fig. 16 Stabilizer Bar Bolt Installation:

4. Reverse procedure to install. Align left edge of marking on stabilizer bar with edge of stabilizer bush, then tighten mounting bolt.