Engine Mount Bracket - Installation

INSTALLATION





1. Install the RH engine mount bracket (1) with six bolts (2) tightened to 25 Nm (18 ft. lbs.).





2. Install the upper timing belt cover (1) with two bolts (2 and 3) tightened to 9 Nm (80 in. lbs.).





3. Install the RH engine mount isolator (3) and support bracket (1) to the engine mount bracket with three bolts. Tighten the isolator to engine bracket bolts in the sequence shown to 60 Nm (44 ft. lbs.).
4. Install the RH engine mount isolator (3) to the body with three bolts (2). Tighten the isolator to body bolts (2) to 60 Nm (44 ft. lbs.).





5. Install the pressurized coolant bottle (5) Coolant Recovery Bottle - Installation.





6. Raise and support the vehicle Maintenance.
7. Install the tunnel support brace (2) with four bolts (1) tightened to 90 Nm (60 ft. lb.).





8. If equipped with a manual transmission, install the rear engine mount isolator (7) to the transmission with the rear engine mount bracket bolt (3) and nut (6) tightened to 80 Nm (59 ft. lbs.) and tighten the isolator bolt (1) to 130 Nm (96 ft. lbs.).





9. If equipped with an automatic transmission, install the rear engine mount isolator (5) in the bracket (3) with two bolts (4) tighten to 60 Nm (44 ft. lbs.). Install the isolator bolt (1) and tighten to 130 Nm (96 ft. lbs.).





10. Install the belly pan Belly Pan - Installation.





11. Lower the vehicle.
12. Connect the fuel vapor purge hose (3) to the intake manifold.
13. Connect the fuel line (2) to the fuel rail and close the hose retainer (1)Service and Repair.





14. Install the air cleaner body (6) Air Cleaner Body - Installation.





15. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lb.).
16. Install the engine cover (1).
17. Run the engine until it reaches normal operating temperature. Check cooling system for correct fluid level Service and Repair.