Engine Mount Bracket - Removal

REMOVAL





1. Perform the fuel pressure release procedure Service and Repair.
2. Disconnect and isolate the negative battery cable.
3. Remove the engine cover (1).





4. Remove the air cleaner body (6) Air Cleaner Body - Removal.





5. Disconnect the fuel vapor hose (3) from the intake manifold.
6. Open the hose retainer (1). Disconnect the fuel line (2) from the fuel rail Service and Repair.





7. Raise and support the vehicle Maintenance.
8. Remove the belly pan Belly Pan - Removal.





9. Remove four bolts (1) and the tunnel support brace (2).





10. If equipped with a manual transmission, remove the rear engine mount bracket bolt (3) and nut (6), loosen the isolator bolt (1) and reposition the rear engine mount isolator (7) away from the bracket (5).





11. If equipped with an automatic transmission, remove two bolts (4) from the rear engine mount bracket (3), loosen the bolt (1) and reposition the rear engine mount link (5) away from the bracket (3).





12. Lower the vehicle.
13. Reposition the coolant recovery bottle (5) Coolant Recovery Bottle - Removal.





14. Support the engine with a floor jack positioned under the oil pan.
15. Remove six bolts (1 and 3) and the RH engine mount isolator (4).





16. Remove the bolts (2 and 3) and the upper timing belt cover (1).





17. Carefully raise the front of the engine and remove the six bolts (2) and the RH engine mount bracket (1).